SPX Nemisys Guia De Inicio Rapido página 13

Figure 10: Vehicle Identification — Series of Screens
3 Do any of the following on the Vehicle Identification screens:
•
On each screen that appears, use the Arrow keys to select the correct option
and then press the ENTER key. Do this until the vehicle is completely
identified and the Required Cables illustration appears. Then go to step 4.
•
To move backward through the screens, one at a time, use the EXIT key.
•
To return to the first Vehicle Identification screen and start over, press the
function key that corresponds to the New button.
•
To reuse information saved for a vehicle already tested, press the function
key that corresponds to the Reuse button. This displays the Reuse Vehicles
screen. Use the Up and Down Arrow keys to select a vehicle description
and then press the ENTER key. This displays the Required Cables
illustration. Go to step 4.
Note: The Reuse Vehicles list holds five (5) descriptions. When full, old
descriptions delete as you enter new ones. To prevent a description from
deleting, select it and press the Save function key. This places a disk icon by the
description. (Use the Delete function key to delete a selected description.)
•
To display demonstration data in the software, press the function key that
corresponds to the Demo button. A checkmark in the box indicates the
Demo function is on (press the key again to turn the function off).
•
Any time you select Global OBD II from a screen, the Required Cables
illustration appears. Go to step 4.
4 With the Required Cables screen displayed on the scan tool
continue with "Step 2: Connect the
Note: If the screen states that no cable connection is required, press the
ENTER key and go to
page 13.
Quick Start Guide
Test Startup and Vehicle Connection
Cable" on
"Step 4: Select the Diagnostic
English
(Figure
page 10.
Function" on
10),
9