Step 3: View The Quick Test Results - SPX Nemisys Guia De Inicio Rapido

Test Startup and Vehicle Connection

Step 3: View the Quick Test Results

After you connect the cable and press the ENTER key on the scan tool, use
the following steps if either the System Readiness Test message screen or the
Quick Test results screen appears.
Note: The Quick Tests provide a quick link to the vehicle's PCM for viewing OBD II
emissions readiness tests and DTCs.
Figure 13: System Readiness Test Message Screen and Quick Test Results Screen
1 If the "System Readiness Test, Not all supported tests are complete" message
appears, press the OK function key to continue. The screen displays the message
"Performing Quick Tests" and then displays the Quick Tests results screen, shown
above.
Note: If the system tests are not complete, press the EXIT key twice to
return to the Required Cable illustration screen. Then, start the vehicle,
drive it around for a few minutes, leave the engine running, and press the
scan tool's ENTER key to run the tests again.
2 Use the Up and Down Arrow keys to scroll through the test results.
3 Optionally, print the test results. Refer to
page 19.
4 After viewing the Quick Test results, press the ENTER key.
5 Continue with "Step 4: Select the Diagnostic
12
"Scan Tool Printing
Function" on
English
Procedure" on
page 13.
Quick Start Guide