Step 6, Install Decorative Duct Covers - Monogram ZV850 Instrucciones De Instalación

Ocultar thumbs Ver también para ZV850:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION – VENTED TO THE OUTSIDE
6
INSTALL DECORATIVE DUCT COVERS
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installation
easier.
• Separate the two decorative duct covers.
• Select the inside or top cover with the vent hole
pattern on one end.
For this vented installation to the outside, the hole
pattern should be located at the bottom.
• Locate the 2 supplied duct cover screws.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach the inside duct cover to the hood support at
the top with 2 supplied duct cover screws.
• Locate the stop screw in the hardware bag.
All manuals and user guides at all-guides.com
Installation Instructions
14
• Install the stop screw into one of the two holes and
tighten against the frame to allow the second duct
cover to slide up and pass over.
• Slide the lower duct cover over the installed upper
duct cover and push up past the stop screw location.
• Back out the stop screw far enough to support the
bottom duct cover and prevent it from sliding down
onto the top of the hood.
CAUTION:
The stop screw must be
installed. Failure to do so could result in personal
injury or damage to the duct cover.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zv855

Tabla de contenido