Step 6, Install Decorative Duct Covers - Monogram ZV850 Instrucciones De Instalación

6 INSTALL DECORATIVE DUCT COVERS
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installation
easier.
• Separate the two decorative duct covers.
• Select the inside or top cover with the vent hole
pattern on one end.
For this recirculating installation, the hole pattern
should be located at the top.
• Locate the 2 supplied duct cover screws.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach the inside duct cover to the hood support at
the top with 2 supplied duct cover screws.
• Locate the stop screw in the hardware bag.
All manuals and user guides at all-guides.com
Installation Instructions
INSTALLATION – RECIRCULATING
• Install the stop screw into one of the two holes and
tighten against the frame to allow the second duct
cover to slide up and pass over.
• Slide the lower duct cover over the installed upper
duct cover and push up past the stop screw location.
• Back out the stop screw far enough to support the
bottom duct cover and prevent it from sliding down
onto the top of the hood.
CAUTION:
installed. Failure to do so could result in personal
injury or damage to the duct cover.
19
The stop screw must be