Step 3, Install Lower Support Frame; Step 4, Secure Wiring; Step 5, Size And Install Ductwork - Monogram ZV850 Instrucciones De Instalación

3 INSTALL LOWER SUPPORT FRAME
• Insert lower support frame into the upper support
frame and loosely secure with 8 screws and
washers (4 on the front and 4 on the back sides).
• Adjust the lower support frame up or down
to the desired height above the countertop.
Tighten screws.
IMPORTANT: Again, check to be sure the support is
level in both directions. There is no way to level the
hood after the hood is secured to the frame.
4 SECURE WIRING
• Route house wiring through the ceiling hole
and pull a length to reach the hood junction box.
Front Side
Support
Frames
• Tape the wire to the front of the frame support to
prevent damage during installation and service.
658Dia19
All manuals and user guides at all-guides.com
Installation Instructions
INSTALLATION – RECIRCULATING
Ceiling
Tape
House
Wiring
5 SIZE AND INSTALL DUCTWORK
• Measure from top duct connector (Dim. A)
to bottom of support frame.
– Subtract 3/4" for hood insertion into the bottom
of the frame.
• Cut the 6" dia. duct to the required length.
NOTE: The bottom end of the duct must be flared
slightly, to facilitate installation of the hood.
• Install duct up through support frames onto the
duct connector. Push duct up until it is 3/4" from
the bottom of the support frame flange. See
illustration.
• Seal duct connection with duct tape, making sure
the connection is secured in place.
18
13-5/8 "
"