Electrical Connection; Symbols Used - Hoberg BBQ Compact Manual De Instrucciones

WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Observe the procedures described in
this user manual.
No claims of any kind will be accepted for
damage resulting from use of the appliance
for other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the place of
operation
Place the appliance on a stable, level,
‹
heat resistant surface that is also resistant to
splashing fat.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials. There must be a gap
of at least 15 cm to walls, furniture and other
objects.
Select a setup location so that children
‹
cannot reach the hot surfaces of the appli-
ance.
The mains socket must be easily accessi-
‹
ble and allow fast disconnection in the event
of an emergency.
Do not operate the appliance directly un-
‹
derneath a smoke detector and ensure that
there is sufficient ventilation in order to avoid
triggering a false alarm.
Never place the appliance or parts of
‹
the appliance in the vicinity of strong heat
sources and hot surfaces (e.g., heaters,
oven, grill).
The appliance may not be used or stored
‹
outdoors.
Do not place the appliance at the edge of
‹
the table, it could fall down.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a heat-resistant mat under the feet of the ap-
pliance.
All manuals and user guides at all-guides.com
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
‹
least a 16 A fuse.
‹
aged and is not laid over sharp edges.
‹
tightly, bent, crushed or knotted or come into
contact with hot surfaces.
‹
tripping.
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.
‹
power supply via an extension lead, the cable
cross-section must be at least 1.5 mm².
This indicates an imminent hazardous situ-
ation, which could lead to severe physical
injury or death.
►
danger.
This indicates a possible hazardous situ-
ation, which could lead to severe physical
injury or death.
►
danger.

Electrical connection

Before connecting the appliance, com-
The mains socket must be protected by at
Ensure that the mains cable is undam-
The mains cable must not be pulled
Route the mains cable to prevent risk of
The electrical safety of the appliance is
If the appliance is to be connected to the

Symbols used

DANGER
Follow these instructions to avoid
WARNING
Follow these instructions to avoid
EN 11