Preparing Charger For Use; Charging The Battery, Leds; Mounting The Charger On A Wall - Stihl AL 101 Manual De Instrucciones

5 Preparing Charger for Use

► Hold the charger by the housing. A
recessed handle is provided on the back of
the charger.
► Hang the charger on the wall bracket.
4.10 Cleaning, Maintenance and
Repair
WARNING
■ Harsh detergents, cleaning with a water jet or
sharp objects can damage the charger. If the
charger is not cleaned correctly, components
may no longer function properly or safety devi‐
ces may be rendered inoperative. They may
cause serious injury to persons.
► Clean the charger as described in this User
Manual.
■ If the charger is not serviced or repaired cor‐
rectly, components may no longer function
properly or safety devices may be rendered
inoperative. This may result in serous or fatal
injury to people.
► Do not attempt to service or repair the
charger.
■ If the connecting cable is faulty or damaged:
► Have the connecting cable replaced by a
STIHL dealer.
5 Preparing Charger for Use
5.1 Preparing Charger for Use
Perform the following steps before starting work:
► Make sure the charger is in a safe condition,
4.5.
► Clean the charger,
► If you cannot carry out this work: Do not use
the charger and contact your STIHL servicing
dealer.
6

Charging the Battery, LEDs

6.1 Mounting the Charger on a
Wall
The charger can be mounted on a wall.
b
2
1
c
a
0458-013-9901-A
9.1.
3
e
d
f
f
► Check the following points when mounting the
charger on a wall:
– Suitable fixing materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = 75 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2 Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. The actual charging time may vary
from the charging time indicated. The charging
time is indicated at www.stihl.com/charging-
times.
The charging process starts automatically when
the mains plug is plugged into a socket and the
battery is inserted into the charger. The charger
switches off automatically when the battery is
fully charged.
The battery and the charger warm up during
charging.
2
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery stop glowing: The battery (2) is fully
charged and can be taken out of the charger
(3)
► If the charger (3) is no longer required. Dis‐
connect the mains plug (6) from the wall outlet
(7).
English
3
7
6
5
13