Operating Instructions; Optiheat Control (3 Step Residual Heat Indicator); Automatic Switch Off; The Automatic Heat Up - AEG HE634400XB Manual De Instrucciones

22

Operating instructions

OptiHeat Control (3 step Residual heat indicator)

WARNING!
\ \ Risk of burns from residual heat!
OptiHeat Control indicates the level of the residual heat. The induction cooking zones make
the heat necessary for cooking directly in the bottom of the cookware. The glass ceramic is
heated by the heat of the cookware.
OPERATING INSTRUCTIONS
You operate the hob with the knobs of the oven and control panel of the hob. The Op-
erating Instructions chapter for the oven tells how to operate the knobs.
When a cooking zone operates, it hums for a short time. This is typical of all ceramic glass
cooking zones and does not show that the appliance operates incorrectly.

Automatic Switch Off

The function stops the hob automatically if:
• all cooking zones are off (
• you do not set the heat setting in less than 10 seconds after you start the hob.
• there is an object (a pan, a cloth, etc.) on the sensor field for longer than 10 seconds. The
sound operates until you remove the object.
• the hob gets too hot (e.g. when a saucepan boils dry). Before you use the hob again, the
cooking zone must be cool.
• you use incorrect cookware.
zone stops automatically.
• you do not stop a cooking zone or change the heat setting. After some time
and the hob stops. See the table.
Automatic Switch Off times
Heat setting
Stops after

The automatic heat up

Automatic heat up function sets the highest heat setting for some time, and then decreases
to the necessary level. To switch it on turn the cooking zone knob to the right until you see
in the display. After that set the heat setting immediately.
All manuals and user guides at all-guides.com
).
comes on in the display and after 2 minutes the cooking
-
6 hours
-
5 hours 4 hours
comes on
-
1.5 hours