Depth Adjustment - skilsaw HD77 Instrucciones De Funcionamiento

SM 2610905550 1/03 1/8/03

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen
the depth adjustment lever located between
the guard and handle of saw. Hold the foot
down with one hand and raise or lower saw
by the handle. Tighten lever at the depth
setting desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut,
for minimum splintering (Fig. 3).
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot
to maximum depth of cut setting. Loosen
bevel adjustment lever, set to 0° on quadrant,
retighten bevel adjustment lever first, then the
depth adjustment lever and check for 90°
angle between the blade and bottom plane of
foot with a square (Fig. 4).
BEVEL ADJUSTMENT
Disconnect plug from power source. The foot
can be adjusted up to 45° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on calibrated quadrant.
Then tighten bevel adjustment first, then the
depth adjustment lever (Fig. 5). Because of the
increased amount of blade engagement in the
work and decreased stability of the foot, blade
binding may occur. Keep the saw steady and
the foot firmly on the workpiece.
LINE GUIDE
For a straight 90° cut, use the large notch in
the foot. For 45° bevel cuts, use the small
notch (Fig. 6). The cutting guide notch will
give an approximate line of cut. Make sample
cuts in scrap lumber to verify actual line of
cut. This will be helpful because of the
number of different blade types and
thicknesses available. To ensure minimum
splintering on the good side of the material to
be cut, face the good side down.
4:26 PM Page 9
Operating Instructions
DEPTH ADJUSTMENT
ONE TOOTH LENGTH SHOULD
QUADRANT
0°
FOOT
QUADRANT
90°
VERTICAL CUTS
FOOT
-9-
FIG. 3
LEVER
PENETRATE WOOD FOR
MINIMUM SPLINTERING
FIG. 4
BEVEL
ADJUSTMENT
LEVER
BLADE
90°
FIG. 5
BEVEL
ADJUSTMENT
LEVER
FIG. 6
45°
BEVEL CUTS