BH FITNESS R370 Instrucciones De Montaje Y Utilización página 16

Keep these instructions safe for
future use.
1.- ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there
Fig.0:
The assistance of a second person
is recommended when assembling
this unit.
(1) Main body.
(2) Front stabilizer.
(3) Slide rail.
(4) Rear stabilizer.
(25) Front stabilizer left end cap.
(26) Front stabilizer right end cap.
(35) Stopper.
(36) Seat.
(46) Monitor.
(76) Pumping siphon.
(77) Funnel.
(82) Rail endcap L.
(83) Rail endcap R.
Nuts & Bolts.
(58) Screw M-8x15.
(60) Screw M-8x15.
(66) Screw M-8x15.
(68) Screw M-4x12.
(71) Washer OD20xID8,5x1,5.
(74) Wrench S5.
(75) Wrench S13-17.
(87) Washer OD16xID8,5x1,5.
2.- FITTING THE REAR
STABILIZER.-
Bring the rear stabilizer (4) to the slide
rail (3) Fig.1, insert screws (66) and
washers (71). Use the spanner (75) to
tighten securely.
3.- MOUNTING THE END CAPS
OF THE FRONT STABILIZER.-
Attach the left and right end caps (25)
(26) to the front stabilizer (2). Then
insert the screws (68), Fig.2, and
tighten using spanner (75).
4.- MOUNTING THE FRONT
STABILIZER.-
Keep the main frame (1) upright.
Attach the front stabilizer (2) to the
main frame (1) using screws (60) and
washers (71). Tighten with the allen
wrench (74), Fig. 3.
5.- MOUNTING THE SEAT.-
Insert the seat (36) in the rail (3), in
the direction indicated by the arrow, as
shown in Fig.4.
Attach the slide rail (3) to the main
frame (1) using screws (58).
Insert the stoppers (35) by mounting
screws (60) and washers (87) and
then tighten firmly using the allen
wrench (74).
Mount end caps (82) and (83) at the
end of the aluminium rail as shown in
Fig.4.
6.- MOUNTING THE
ELECTRONIC CONSOLE.-
Attach the monitor (46) to the main
frame (1) using washers (71) and
screws (60). Tighten with allen wrench
(74).
HOW TO FILL AND EMPTY THE
TANK.-
First remove the fill plug (33) from the
upper tank cover, Fig.6/Fig.7.
To fill tank with water (Fig.6), insert
the funnel (77) into the tank, then use
the siphon pump (76) and a bucket to
fill the tank. Use the water level gauge
on the side of the tank to measure
desired water level in the tank.
To empty the tank (Fig.7), place a
bucket next to the rower, and use the
siphon pump (76) to pump out the