BH FITNESS R370 Instrucciones De Montaje Y Utilización página 17

water from the tank into the bucket.
Insert the fill plug (33) into the upper
tank cover. Wipe excess water off of
the frame.
NOTE:
Fill the tank only with tap water. Add 1
water-purification tablet (1 packet is
included.). Never use pool chlorine or
chlorine bleach. This will damage the
tank and void the warranty.
Add a water purification tablet every 6
months or as needed. If water remains
cloudy, replace the water in the tank.
Water from the tank is not suitable for
consumption. Dispose the water after
pumping it out from the tank.
WATER LEVEL.-
The water level gauge is on the side of
the tank. The maximum fill level is 6.
Never fill it over this limit. Filling the
tank over this limit will damage the
machine and void the warranty.
The resistance depends on the water
level in the tank. Water level 1 is the
lowest resistance. Level 6 is the
highest resistance.
ASSISTED
ADJUSTMENT.-
There are 3 hooks (A, B, C) for the
bungee cord, located on the inside of
the frame under the water tank,
(Fig.8). If you hook the bungee cord
on to B or C, it increases the assisted
return of the mesh belt. C is the
fastest return.
PEDAL ADJUSTMENT.-
You can adjust the position of the sole
of the footrest (Fig.9). To do this, pull
the sole upwards, put it in the desired
position and replace it by making the
pivots of the lower part of the footrest
match with the holes in the sole. You
can also adjust the strap of the
footrest with velcro, Fig.9.
LEVELLING.-
Once the unit has been placed into its
final position for doing exercise, make
sure that it sits flat on the floor and
that it is level. This can be achieved by
screwing
blocks (27) up or down, as shown in
Fig.10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels to
make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.11.
You can store the machine upright to
save space, Fig.12. To do this, first
move the seat (36) toward the front of
the rail (3) so that it does not slip when
lifting the machine. Carefully lift the
machine by the side of the rear
stabilizer and place it in an upright
RETURN
position.
Store your unit in a dry place,
preferably not subject to changes in
temperature.
If not using the rower for more than a
month, empty the tank before storing.
Do not hesitate to get touch with the
Technical Assistance Service if you
have
customer services (see last page in
manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
the adjustable
any queries
support
by phoning