Operation Methods; Normal Operation; Adjusting Air Flow Direction - Hiyasu ASE 9U2iM Manual De Funcionamiento

06Manual 24D ENG 2/1/07 13:34
Applicable conditions
Temp./Mode
Note: Don't use your air conditioner beyond above-mentioned conditions, otherwise protection function may work which
may result in malfunction.
Handling the remote controller
Refer to REMOTE CONTROLLER MANUAL.
Note: This model has no ventilation, watering, electric heating functions, so if you push the relative buttons on the remote contro-
ller, nothing will happen.
Manual operations

NORMAL operation

This function is used to operate the unit temporarily in case you misplace the
remote controller or its batteries are exhausted.
1
Open the panel and lift the panel up to angle which remains fixed. Do not lift
the panel any further when it stops with a "click" sound.
2
The two indoor units will operate at the same time when you select "COOL"
mode through the manual button on the display panel.
3
Close the panel firmly to its original position.
Caution
The COOL mode on control panel is used to test only, please don't choose it.

Adjusting air flow direction

Adjusting the Vertical Air Flow
Please remove the vertical louver to adjust the air-flow direction as required
manually.
When the unit is operating and horizontal louvers are on certain position, take
hold of the left or right lever on the horizontal louvers and move them to adjust
the air flow direction as required.
Adjusting the Horizontal Air Flow
Please use the remote controller to adjust horizontal louvers so as to adjust the
vertical air flow direction.
Caution
The starting angle of the horizontal louver should not be too small, or the narrow air outlet will affect cooling or heating.
•
• Do not move the vertical louver manually, or it may malfunction during operation, If the malfunction happens, please stop operating unpluge for seve
ral minutes then plug again and restart.
• Do not operate the air conditioner for long with the airflow direction set downward during the cooling or drying operation. Otherwise, condensation
may occur on the surface of the vertical louver and cause dew dripping.
• When the air conditioner restarts the vertical louver might not move for 10 seconds or so.
• At the first time to operate, there may be some noise when horizontal louver is turning, it is under control.
46
Página 46

OPERATION METHODS

Cooling
Heating
Indoor temp.
17º C above
17º C ~ 43º C
Outdoor temp.
30ºC below
7º C ~ 21º C
Manual Button
Lever
•