Beem Espresso-Classico Manual De Instrucciones página 31

29
3. Press the
small amount of water always runs through. The device is now ready for operation. You will
hear two beeps.
After it has been used several times, there is usually still water in the water system, which
means that the device is soon ready for operation.
•
Press the
fl ashes during the heating process.
• Press the
Programming Quantities
Both the quantity of espresso and the quantity of milk can be programmed for each function. This
allows you to set the perfect quantity of espresso and milk to suit your own taste.
The set quantities are saved until a new quantity is set.
Espresso, Double Espresso, Milk Froth
1. Fill the device with water and espresso or additionally with milk (see the "Preparation" chapter).
2. Fold out the milk nozzle (4) if necessary using the lever (5) (Picture G).
3. Place a suitable cup below the coffee outlet (11) or the milk nozzle.
4. Select the function that is to be reprogrammed by pressing the appropriate button (a beep
sounds) and holding it (another beep sounds).
5. The device starts to prepare espresso or make milk froth.
6. Only let go of the button once the quantity of milk or espresso that you want has passed
through. You will hear three beeps. This quantity is now saved under the corresponding function.
Cappuccino and Latte Macchiato
This process must be carried out twice for latte macchiato and cappuccino: once for the
quantity of espresso and once for the quantity of milk.
1. On the fi rst operation, set the quantity of milk you want in the manner described in the
previous section. Make sure that the milk nozzle (4) is folded out and there is a cup below the
milk nozzle.
2. Start a second operation by pressing the appropriate button again. A beep is heard.
3. Wait until the quantity of milk has passed through.
4. As soon as the device starts to make espresso, press the appropriate button again and hold it
down. Another beep sounds.
5. Only let go of the button again once the quantity of espresso that you want has passed
through. You will hear three beeps.
Now both the quantity of milk and the quantity of espresso are saved under the appropriate
function.
07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 29 07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 29
button (19). The device draws water and fi lls the water system with liquid. A
button (21) to switch on the device and preheat the water. The control panel
button to switch off the device.
EN
21.06.2021 10:50:12 21.06.2021 10:50:12