Troubleshooting - Beem Espresso-Classico Manual De Instrucciones

35

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem yourself.
If the problem cannot be solved with the steps that are listed, contact our customer service
department.
Do not attempt to repair a defective electrical device yourself!
Problem
The control panel (15)
does not light up /
the device cannot be
switched on.
The fuse in the fuse
box is triggered.
Water runs out of the
device.
A function has
been selected, but
the device beeps
constantly and the
red control lamp (20)
fl ashes. The control
panel (15) does not
light up.
The red control
lamp (20) is lit up
permanently.
The yellow control
lamp (22) fl ashes.
The espresso runs
very slowly into the
cup.
07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 35 07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 35
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
Too many devices connected to
the same circuit.
There is too much water in the
water tank (16).
The water tank (16) is not placed
in its mount correctly.
There is no water in the water
tank (16).
The device is defective.
The device is furred up.
The coffee outlet (11) or the
sieve (8, 9) is clogged.
The device is furred up.
Fix
Correct the fi t of the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Reduce the number of devices in
the circuit.
Do not overfi ll the water tank!
Correct the fi t of the water tank.
Detach the water tank from the
device and fi ll it with water.
Place a cup beneath the coffee
outlet (11).
Press any button. Some water
will run through the water
system into the cup. The red
control lamp will go out, the
device will stop beeping and can
be restarted.
Contact the customer service
department.
Descale the device.
Clean the portafi lter (10) and
the sieve.
Descale the device.
21.06.2021 10:50:30 21.06.2021 10:50:30
EN