Technoline WS 9900 Manual De Instrucciones página 17

temperature and the time as 0:00 will be displayed. If they are not
shown in LCD after 60 seconds, remove the batteries and wait for
at least 60 seconds before reinserting them.
4. The outdoor temperature from the first sensor (channel 1) should
be displayed on the temperature station. Also, the signal reception
icon will be displayed. If this does not happen after 40 seconds,
the batteries will need to be removed from both units and reset
from step 1.
5. Insert the batteries to the second sensor immediate after (in 10
seconds after) inserting battery to the temperature station.
6. The outdoor temperature from the second sensor and the "channel
2" icon should then be displayed on the temperature station. If this
does not happen after 40 seconds, the batteries will need to be
removed from all the units and reset from step 1.
7. Insert the batteries to the third sensor immediate after (in 10
seconds after) inserting battery to the second sensor.
8. Then within 40 seconds, the channel 3 outdoor data from the third
sensor will be displayed and the channel icon will shift back to "1"
once the third sensor is successfully received. If this is not happen,
user shall restart the setting up from step 1.
.
Note:
After the three sensors have been set up, user may need to check the
readings displayed on the temperature station against those being
shown on the sensor displays, in order to recognize on which channel
each sensor is being presented.
Important:
Transmission problems will arise if the setting for additional sensors is
not followed as described above. Should transmission problems occur,
it is necessary to remove the batteries from all units and start again the
set-up from step 1.
How to install and replace batteries in the temperature station
The temperature station uses 2 x AAA, IEC LR3, 1.5V batteries. When
batteries will need to be replaced, the low battery icon will appear on
the LCD. To install and replace the batteries, please follow the steps
below:
EN3