Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Fix a screw (not supplied) into the desired wall, leaving the head
extended out the by about 5mm.
2.
Hang the temperature station onto the screw. Remember to
ensure that it locks into place before releasing.
Positioning the temperature sensors:
The sensor is supplied with a holder that may be attached to a wall with
the two screws supplied. The sensor can also be position on a flat
surface by securing the stand to the bottom to the Sensor.
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic
anchors.
2. Clip the remote temperature sensor onto the bracket.
Note:
Before permanently fixing the sensor wall base, place all units in the
desired locations to check that the outdoor temperature reading is
receivable. In event that the signal is not received, relocate the sensors
or move them slightly as this may help the signal reception.
Care and maintenance:
Extreme temperatures, vibration and shock should be avoided as
these may cause damage to the unit and give inaccurate forecasts
and readings.
When cleaning the display and casings, use a soft damp cloth
only. Do not use solvents or scouring agents as they may mark the
LCD and casings.
Do not submerge the unit in water.
Immediately remove all low powered batteries to avoid leakage
and damage. Replace only with new batteries of the recommended
type.
Do not make any repair attempts to the unit. Return them to their
original point of purchase for repair by a qualified engineer.
Opening and tampering with the unit may invalidate their
guarantee.
Do not expose the units to extreme and sudden temperature
changes, this may lead to rapid changes in forecasts and readings
and thereby reduce their accuracy.
EN9
Publicidad
