Suggestions And Tips - Haier HD90-A636-E Manual Del Usuario

Suggestions and tips

EN
Starched laundry
Starched laundry leaves a fi lm of starch in the drum and is not suitable for the dryer.
Softener
Do not use softener when washing, because the laundry will become soft and fl uff y in the
dryer.
Soft care cloths
The use of "soft care cloths" can lead to a coating at the lint fi lters. This can cause a block-
age of the fi lters. In such cases, we recommend either to abstain from adding soft care
cloths or to choose a diff erent brand. In any case note the manufacturer's instructions.
Small amounts of fi lling
In a quantity of less than 1.0 kg, the "Timer"-programme should be selected because
the automatic scanning of the dry level can be captured only still inaccurate.
Open door
The door should be left ajar during the non-use, so that the door seal indefi nitely remains
in eff ect.
Drum interior light
When the appliance is switched on, always the drum interior light lights when door is open .
Service fl ap
Make sure that the service fl ap is always closed during operation.
Anti crease protection
If at the end of the programme the laundry is not removed, the drum moves from time to
time to prevent creasing. The anti crease protection phase is approx. 60 minutes.
Laundry which should be ironed
...should be dried with level READY to IRON . This facilitates ironing by hand or using
the machine.
Remaining time
The programme duration is infl uenced by the following factors: the type of fabric, the fi lling
quantity, absorptive capacity, the desired dry level, as well as the spin speed of the washing
machine. These factors are registered by the electronics during the programme and the
remaining time will be corrected accordingly.
AUTO load detection system
When the programme starts, after a few minutes the display will show . This means
the automatic load detection is in progress. Sensors are detecting and estimating the se-
lected programme time to fi nish. Depending on the programme selected, load quantity,
humidity and ambient temperature, the AUTO load detection phase can last a few minutes
for small load, or up to hour for the maximum load or large items, before displaying the ap-
proximate programme time remaining to fi nish the programme.
15