Lightbulb: Removal & Replacement; General Maintenance - Dirt Devil F23 Manual Del Usuario

All manuals and user guides at all-guides.com
11
LIGHTBULB: REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134
or your local auto parts store.
1.
1a.
Using the end of a Flathead screwdriver, gently
pop open the lens (Diagram 1). Remove lens
(Diagram 1a).
GENERAL MAINTENANCE
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
DEBRIS REMOVAL/ DEBRIS REMOVAL/
HOSE NOZZLE GUARD
1. 2. 3.
DEBRIS REMOVAL/POWER BRUSH TOOL
4. 5.
LOCKING RING
Rotate locking ring 180˚ and Pivot lower housing and
turn Power Brush Tool over. remove clog.
2. 3.
Pull bulb out of socket. Replace lens by aligning
Do NOT twist. Gently tab and snapping into
push bulb into socket place.
to replace.
• Check to see if dirt container is full; empty if
needed.
• Plug cleaner in and check to see if there is any
suction at end of hose. If there is suction at
end of hose, move on to Diagram 4. If there is
no suction at the end of hose, follow these
steps:
1. Unwrap hose from caddy. Twist and
unlock to remove clogs. Clean out hose with
a broom handle. Check access door on back of
cleaner (near hose end). Remove the seven (7)
screws and check for obstruction (Diagram 1).
2. Remove dirt container (Pg. 8) and check dirt
container inlet located on cleaner (Diagram 2).
3. Remove nozzle guard (see Diagram 3) by
removing the three (3) screws. Remove
obstructions (Refer to Page 10 for belt
and brushroll removal and replacement).
6.
To reassemble, be sure tabs
are engaged. Pivot the lower
housing closed.
11