2
Safety Notes
This unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains volt-
age. Leave servicing to skilled per-
sonnel only and do not insert any-
thing into the air vents! Inexpert
handling of the unit may result in
electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
Do not place any vessel filled with liquid on the
unit, e. g. a drinking glass.
G
The heat generated inside the unit must be dissi-
pated by air circulation; never cover the air vents
of the housing.
G
Do not operate the unit or immediately discon-
nect the mains plug from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely installed or not correctly connected or
operated, or if it is not repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
3
Applications
This LED spotlight is used for illumination, e. g. on
.
stage, in clubs and ballrooms. As a light source,
seven extra bright 3 W RGB LEDs are used. Com-
pared to incandescence lamps, they feature a low
power consumption, a low heat generation and a
long life. The LEDs are able to emit coloured light
in the three primary colours red, green and blue
light, but also light created by additive colour mix-
ing. Crossfading from one colour to another and
stroboscope effects are also possible.
The spotlight is designed for control via a DMX
light controller (6 DMX control channels available),
but it is also possible to operate it on its own or in
combination with several PARL-73RGB spotlights
(master / slave mode). In addition, the integrated
microphone provides effects in sync with the music.
4
Installation
When placing the unit, always ensure a sufficient
air circulation during operation. Never cover the air
vents of the housing.
WARNING Install the spotlight safely and
1. Fasten the spotlight via a mounting bracket (7) ,
e. g. with a stable mounting screw or a support
for lighting units (C-hook) on a crossbar.
To adjust the spotlight, release the two lock-
ing screws (3) on the mounting bracket, adjust
the desired inclination of the spotlight, then
retighten the screws.
2. Alternatively, place the spotlight as desired. Use
the mounting brackets as a stand; position them
under the spotlight so that they will support it.
Then fasten the locking screws.
expertly. When installing it at a place
where people may walk or sit under
it, additionally secure it (e. g. via a
safety rope on the mounting bracket;
fasten the safety rope in such a way
that the maximum falling distance of
the unit will not exceed 20 cm).
GB
11