Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Measuring negative pressure
in the combustion chamber
Replacement parts
Above the combustion chamber opening there is a
measuring duct on which the negative pressure in the
combustion chamber can be measured with the door
closed during heating operation.
Attention:
Please ask your specialist trader for any replacement
We guarantee a ten-year availability of spare parts.
is imperative that you send us the type and fabrication
number given on the stove's rating plate.
storing compartment.
We recommend the relevant numbers here before in-
stalling the stove to ensure that you always have them
to hand:
Type number: 23/__________
Fabrication number: __________________________
parts required. Always use original spare parts only.
In order to process your order as quickly as possible, it
The stove identification plate is situated in the wood
measuring duct
What to do if ...?
... the stove doesn't draw properly?
● Is the chimney or the stovepipe not tight?
● Has the chimney been incorrectly designed?
● Is the external temperature too high?
chimney open?
... the room doesn't get hot?
● Is the waste gas pipe blocked?
● Is the combustion air supply been closed?
● Is the chimney draught too low?
● Is the wood used as fuel not dry?
... the stove gives off too much heat?
● Is the combustion air supply open too wide?
● Is the delivery pressure too high?
... the grate becomes damaged or slags are formed?
● The stove was overloaded.
● The ash pan was not emptied in good time.
... a fault occurs?
● Do not add any more fuel.
● Do not open the combustion chamber door.
controlled fashion.
department.
● Inform the chimney sweep.
● Have a professional determine the cause?
● Are the doors of other fireplaces connected to the
● Is the heating requirement too high?
● Allow the fire in the chimney to burn itself out in a
... the chimney catches fire?
● Minimize the air supply to the stove and call the fire
15
Publicidad
Capítulos
Tabla de contenido
