Zoom Mode; Led Displays On The Flash Unit; Flash Readiness Indication; Correct Exposure Indication - Metz mecablitz 52 AF-1 Olympus digital Manual De Instrucciones

Setting the automatic unit switch-off
• Switch on the flash unit with the
button. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last
(e.g. manual flash mode M).
• Press the
for the selection menu to appear.
• Press the
touch display.

ZOOM MODE

• Press the
STANDBY
touch display and select „STANDBY".
MOD.LIGHT
• Press the
touch display.
STANDBY
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
Off
immediately. The operation display
41 min
appears after about 10 seconds, or press
D
10 min
the
operation display appears.
D
The button flashes red in stand-by
mode.
D
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
STANDBY
sensor button on the
button repeatedly until the

4 LED displays on the flash unit

4.1 Flash readiness indication

When the flash capacitor on the flash unit is
charged, the button lights up in green,
thus indicating that the flash unit is ready.
This means that flash light can be used
for the next shot. Flash readiness is also
transmitted to the camera and indicated
accordingly in the camera's viewfinder.
If a photograph is taken before flash
readiness appears, then the flash unit will
not be triggered. If the camera has already
switched to flash sync speed, the shot may
have the wrong exposure (see 13.1).

4.2 Correct exposure indication

If the exposure is correct, then button
lights up in red for around 3 seconds if the
photograph has been correctly exposed in
flash modes TTL and TTL FP (see 7.1)!
If there is no exposure control indication
after the shot, then the photograph was
underexposed. In that case, you must:
- set the next smaller f-stop (e.g. use f-stop 8
instead of 11), or
D
k
137