6 Displays in the camera viewfinder
Examples for the camera display:
Flash symbol flashes:
Prompt indicating that the flash unit is to be
switched on or used (by some cameras).
Flash symbol is illuminated:
The flash unit is ready for use (by some
cameras).
For information applicable to the displays in
the viewfinder of your camera model, refer to
the camera's operating instructions!
k
140
7 Flash modes
You can choose from the following operating
modes:
- TTL
- TTL FP
- M
- M FP
- REMOTE-SLAVE
- M-SERVO
The flash mode is set using the touch
display.
7.1 TTL-flash mode
These flash modes offer a very simple
method of obtaining very good flash shots.
Here, the exposure is measured by a sensor
in the camera. It measures the light reflected
by the subject through the lens (TTL =
"Through The Lens").
If the shot was exposed correctly, the correct
exposure indication will illuminate for about
3 seconds (see 4.2).
Please note whether there are limitations for
your camera in terms of film sensitivity for TTL
flash mode (for example, ISO 64 to ISO 1000;
see camera's operating instructions)!
When taking a shot, an almost imperceptible
measurement pre-flash is triggered by the
camera prior to the actual exposure process.