Home Decorators Collection GAZELLE 91150 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the mounting plate (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (GG) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (GG) and lock
washers (HH) in the round holes. This will enable you to
remove the mounting bracket (A).
A
HH
GG
C
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the two setscrews (II) on the
collar (JJ) on top of the motor housing.
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (JJ) on top of the motor housing.
□
Carefully insert the hanger pin (EE) through the holes in
the collar (JJ) and downrod (B). Be careful not to jam the
hanger pin (EE) against the wiring inside the downrod (B).
□
Insert the locking pin (FF) through the hole near the end of
the hanger pin (EE) until it snaps into its locked position.
□
Re-tighten the two setscrews (II) on the collar (JJ) on top
of the motor housing.
2
Routing the wires
□
Make sure the slot openings are on top, route the
wires through the coupler cover (D), canopy (C), and
then through the ball/downrod assembly (B).
GG
FF
II
7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
D
B
E
B
EE
JJ