Oven Light; Remove/Replace Drawer - Sears Kenmore Elite 664.9522 Serie Manual De Uso Y Cuidado

CONTROL PANEL AND OVEN DOOR EXTERIOR
To avoid damage to the control panel, do not use abrasive
cleaners, steel-wool pads, gritty washcloths, or abrasive
paper towels.
Cleaning Method:
Glass cleaner and soft cloth or sponge:
■
Apply glass cleaner to soft cloth or sponge, not directly
on panel.
Kitchen and appliance cleaner (Part Number W10355010
■
may be ordered from sears.com. See the back cover of this
Use and Care Guide for additional contact information.)
OVEN RACKS
Cleaning Method:
Steel-wool pad
■
For racks that have discolored and are harder to slide,
■
a light coating of vegetable oil applied to the rack guides
will help them slide.
WARMING DRAWER
Check that warming drawer is cool and empty before
cleaning.
Cleaning Method:
Mild detergent
■
OVEN CAVITY
Use Lo Temp Clean regularly to clean oven spills.
Do not use oven cleaners.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain. Staining, etching,
pitting, or faint white spots can result.
Do not clean the oven door gasket.
Cleaning Method:
Clean cycle:
■
See the "Clean Cycle" section.

Oven Light

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the Off position.
A. Oven light
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
24
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
Remove all items from inside the warming drawer, and then
allow the range to cool completely before attempting to
remove the drawer.
To Remove:
1. Open the drawer to its fully open position.
2. Using a flat-blade screwdriver, gently loosen the drawer
from the glide alignment notch, and then lift up the drawer
alignment tab from the glide.
3. Repeat Step 2 on the other side. The drawer is no longer
attached to the drawer glides. Using both hands, pick up
the drawer to complete the removal.
To Replace:
1. Align the forward drawer notches with the notches in the
drawer glides on both sides. Place the rear alignment tabs
into the drawer glides on both sides.
A
2. Push the drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the glides on both sides.

Remove/Replace Drawer

C
A. Flat-blade screwdriver
B. Drawer alignment tab
C. Drawer glide notch
B
A. Drawer alignment tab
B. Drawer glide notch
A
B
A