Functional Description - Milwaukee 5316-20 Manual Del Operador

SYMBOLOGY
Volts
Alternating Current
Amps
No Load Revolutions per Minute (RPM)
BPM
Blows per Minute (BPM)
Anti-Vibration System
UL Listing for Canada and U.S.
C US
Approval Mark for Mexico

FUNCTIONAL DESCRIPTION

3
2
1. Side handle
2. Bit holder
3. Bit release collar
4. Mode selector
knob
5. Trigger
1
6. Handle
4
5
To reduce the risk of injury, always
WARNING
unplug tool before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or
hold securely.
Adjusting the Side Handle Position
1. Loosen the side handle by unscrewing the side
handle grip until the side handle rotates freely.
2. Rotate the side handle to the desired position.
3. Tighten the side handle grip securely.
To reduce the risk of injury, do not
WARNING
grasp the bit while the chuck is
rotating or while the bit is falling from the chuck.
Installing Bits and Chisels
Be sure that the shank of the bit is clean. Dirt particles
may cause the bit to line up improperly. Do not use
bits larger than the maximum recommended capacity
of the drill because gear damage or motor overload-
ing may result. For best performance, be sure that
6
the bit is properly sharpened and the shank is lightly
greased before use. Use caution when handling hot
bits and chisels.
SDS-Max Drive System
1. Unplug tool.
2. Insert the bit or chisel into the nose of the tool.
3. Push bit into tool until it locks.
5. Check to see that the bit is locked by tugging on it.
6. To remove bits and chisels, pull back on the bit
release collar and remove bit.
Spline Drive System
1. Unplug tool.
2. Insert the bit or chisel into the nose of the tool.
If you are using a rotary bit, make sure that the
splines on the shank engage with the splines
inside the nose of the tool.
If you are using a chisel, make sure that the notch
in the shank faces up.
3. Push bit into tool until it locks.
4. Check to see that the bit is locked by tugging on it.
5. To remove bits and chisels, pull bit release collar
toward the rear of tool and remove bit.
4
ASSEMBLY