Fitting The Header Assembly - NAMCO 500 GP Dlxe Manual Del Operador

5-1

Fitting the Header Assembly

The Header Assembly has a forward centre of gravity, so it is important that at least
two people are used to fit or remove the Header Assembly.
The fitting position of the Header Assembly is very high, and it is important that a
means of reaching the height safely, without stretching, is available. (e.g. steps, step
stool etc.)
1. Place the header on to the monitor cabinet and slide it backwards so that it
engages under the fixing brackets.
2. Retain the header in position with 3off hex head screws (M6x25) with flat and
spring washers.
3. Remove 2off pozi hed screws (M5x15), and remove the Connector Cover.
4. Connect the connector.
5. Refit the connector cover with the 2off security screws (M5x15).
(M5x15)
Page 35
(M6x25