OFFCAR 80PQG10D Uso E Manutenzione página 66

−
Here is a list of the procedures for a safe and correct use of the appliance.
Lighting the pilot burner:
−
Open the gas cock before the appliance.
−
Turn the knob from position "" leftwards to the position "", press the knob and together press the
piezoelectric ignition button repeatedly..
−
Once the pilot flame is on, keep the knob pressed for a few seconds until the thermocouple heats up.
Starting cooking – igniting main burner:
−
Turn the knob leftwards to the position "
−
Generally cooking is started by setting the knob on the maximum heating position and once the vat has
reached cooking temperature, the knob is turned to the minimum position to maintain the cooking temperature.
End of cooking – turning off main burner and pilot burner:
−
Turn the knob rightwards until position "" to turn off the main burner; only the pilot flame will be lighted.
Turn the knob again until position "" to turn off the pilot burner. (See also figure "Controls").
3.3. CLEANING AND CARE OF THE APPLIANCE
−
Do not use aggressive substances or abrasive detergents when cleaning the stainless steel components.
−
Avoid using metal pads of the steel parts as they may cause rust. For the same reason avoid contact with
materials containing iron.
−
Do not use sandpaper or abrasive paper for cleaning; in special cases use a powder pumice stone.
−
In case of particularly resistant dirt, it is advisable to use abrasive sponges (e.g. Scotch-Brite).
−
It is advisable to clean the appliance only once it has cooled down.
Warning! : When cleaning the appliance never use direct jets of water to prevent infiltration of the
liquid and damage to components.
−
Clean the cooking vat with water and a detergent, rinse thoroughly and dry well with a soft cloth.
−
External surfaces should be washed down using a sponge, and hot water with a suitable proprietary
cleaner addend.
−
Rinse always thoroughly and dry with a soft cloth.
Note for pressure kettles:
−
Do not use detergents containing high percentages of ammonia and sodium to clean the lid gasket, as
these substances may cause damage and quickly affect the tightness of the gasket.
3.4. SPECIAL PROCEDURES IN CASE OF PROLONGED INACTIVITY
−
If the appliance is to stand idle for any length of time (e.g. holidays or seasonal closing) it must be
cleaned thoroughly, leaving not traces of food or dirt.
−
Leave the lid open so that air can circulate inside the vat.
−
For added care after cleaning, the external surfaces can be protected by applying a proprietary metal
polish.
Instruction manual for installation, maintenance and use
Gas Kettles
"or until minimum position "
3.3.1. DAILY CLEANING
" to light the burner.
- GB - 15 di 25
Page