Rear-Facing Installation; Lower Anchor Installation - Britax EMBLEM Guia Del Usuario

BRITAX Child Safety, Inc.

Rear-Facing Installation

IMPORTANT: The infant positioning pillow must be used
to achieve better fit and support for infants weighing up
to 22 lbs (10 kg) in a rear-facing position. Do not use
pillow over 22 lbs (10 kg) or in a forward-facing position.
See page 24.

Lower Anchor Installation

1. Remove the lower
connectors from the
storage slots in the base.
Press the adjuster release
button and pull the strap
to full length. Repeat for
the second strap.
2. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
24). Ensure that no more
than 3 in. (7.6 cm) of the
base hangs over the edge
of the vehicle seat.
3. Firmly press the lower
connectors onto the
adjacent lower anchors
until a click confirms
attachment.
4. Push the child seat
down while pulling each
lower connector strap to
tighten.
8
Rear-Facing Installation with Lower Anchors
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
3"
9 Check that the child seat cannot be moved front to back
or side to side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 After the child is secured, check that the recline angle
of the child seat is 30° – 45° from vertical (not to exceed
45°) when the car is parked on a level surface. See "Seat
Positions" on page 24.
1
EMBLEM/ALLEGIANCE User Guide
9