Anti-Rebound Bar (Select Models); Using The Lower Anchors And Tethers For Children (Latch); Lower Connectors - Britax ADVOCATE CLICKTIGHT Guia Del Usuario

Britax Child Safety, Inc.

Anti-Rebound Bar (Select Models)

In the event of a crash, the anti-rebound bar is designed to
prevent rebound rotation in rear-facing car seat installations.
The anti-rebound bar is not intended for use as a carry
handle. Do not use the anti-rebound bar to carry this child
seat.
IMPORTANT: The anti-rebound bar MUST be removed for
forward-facing installation.
Installing the Anti-Rebound Bar
1. Open the CLICKTIGHT.
2. Pull back on the shell
cover behind the red
marker and locate the
open end of the structure
tube.
3. Insert one end of the anti-
rebound bar into the tube
as shown, then repeat for
other side.
4. Lift up on the anti-rebound
bar to ensure both ends
are properly set inside the
structure tubes.
NOTE: Closing the CLICKTIGHT will completely secure
the anti-rebound bar.
Removing the Anti-Rebound Bar
1. Open the CLICKTIGHT.
2. Grasp the anti-rebound
bar at both sides and pull
away from the child seat.
28
ADVOCATE/BOULEVARD CLICKTIGHT User Guide

Using the Lower Anchors and Tethers for Children (LATCH)

The Lower Anchors and Tethers for Children or LATCH, is a
system available on this child seat that offers an alternative
to vehicle seat belt installation methods. The figure below
shows typical locations for lower anchors and tether anchors
in a vehicle. See pages 2-3 for LATCH components on this
child seat.
LATCH SYSTEM ANCHOR LOCATIONS
Lower Anchors
11 in. (27.9 cm)
Tether
Anchor
Check your vehicle owner's manual to learn if it is equipped
with LATCH, the maximum weight rating for the lower
anchors, tether anchors capacities, and information on the
lower anchor locations and designated seating positions
available for use with this child seat.

Lower Connectors

Using the Lower Connectors
The lower connectors are located in the back of the base
of the child seat. Store the connector assembly in the
compartment when not in use.
To attach the lower connectors:
1. Remove the lower
connectors from the
storage compartment at
the rear of the seat and
pull the strap to full length
toward the child's left
side.
2. Press the lower connector
hook over its adjacent
lower anchor. For full
installation instructions see
pages 10-11 or 16-17.
Lower
Anchors
29