Preparations For Rear Operator Mountings On Masonry Posts; Preparations For Rear Operator Mounting On Masonry Posts With Inset - Aprimatic ZT42 Serie Instrucciones Para La Instalación

R
3.2.2 Preparations for rear operator
mounting on masonry posts
If the supporting posts for the gate leaves are made
from masonry, then metal mounting of the operator.
Three ways of doing this are shown in fi g. C4:
A - Plate with hooked fi tting
B - Plate with stud bolts, either glued or pressure-
fi tted
C - L-plate with stud bolts, either glued or pressure-
fi tted
Caution
• The size of the plates, apart from standard
APRIMATIC plates, must be proportional to the
size of the columns.
• If the A-type plate is used and has to be positioned
in line with the operator axis, the hook fi ttings
must be modifi ed as shown in fi g. C 5.
3.2.3 Preparations for rear operator
mounting on masonry posts with
inset
If mounting insets have to made in the posts for the rear
operator mounting with metal plates, the measurements
shown in fi g. C7 must be adhered to.
Remember that the inset is necessary when the
distance between the edge of the post and the center
of rotation of the gate leaf is greater than the distance Y
(C1), or when the gate leaf is anchored to a continuous
wall.
REAR OPERATOR MOUNTING - SPECIAL CASES
For outward-opening gate leaves, the rear mounting
has to modifi ed using an L-plate, as shown in C6. In this
particular case, as the operators have a hydraulic lock,
the A-type hydraulic lock must be used.
REAR OPERATOR MOUNTING
If the post is made out of iron, the operator rear
mounting plate can be welded directly on to the post,
welding as shown in C2 and C3. If the post is made
from masonry, proceed as follows:
• For each post, prepare an iron anchorage plate (see
C4 for size of plate).
• Cut the insets into the posts (see C7 for size of
inset).
C4
B
A
APRIMATIC
APRIMATIC
* MUST BE CUT TO MEASURE
(not supplied by Aprimatic)
C6B
For dimensions A,B and C
consult table C1
C7
Y
- 19 -
Installation
C
*
Inside entrance
max. from hinge axis
to plate edge
C5