Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Powder Coated & Stainless Steel Restroom Partitions, Floor-Braced — Series 500
8
Door Hardware for Inswing Doors - Concealed
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
A
Assemble the latch as shown . Tighten the fasteners and insert
the latch bolt, pushing in until it snaps into place .
Place the strike/keeper on the pilaster and center it on the opposing latch
B
bolt . Using the strike/keeper as a template, mark the hole locations on the
pilaster . Remove the strike/keeper and drill an Ø1/4" hole through the pilaster .
Secure to the pilaster with the #10-24 x 3/4" barrel nut and
#10-24 x 1" shoulder screw provided .
C
For 34" - 36" doors, mark the location for the top hole on the inside face of the door 30-3/4" (781mm) up from the bottom of 58" tall
doors (42-3/4" (1086mm) above finished floor) and 4" (102mm) from the door edge . Drill (2) Ø1/4" holes (spaced 3-1/2" (89mm)
apart) through the door and secure the door pulls to the door with the #10-24 x 2" flat machine screws provided .
3"
(76mm)
3"
(76mm)
22
4"
(102mm)
30-3/4" (781mm)
(Bottom of Door)
42-3/4" (1086mm)
A .F .F
Place the coat hook 3"
(76mm) down from the top
and 3" (76mm) from the latch
side of the door (hook goes
D
on the inside face of the
door) . Using the coat hook
as a template, drill (2) Ø9/64"
pilot holes through inside face
of the door only . Secure the
coat hook with the #10 x 5/8"
screws provided .
3/22/2018
Flat Strike/Keeper
With the door in the closed
E
position, place flat strike/
keeper so the slot is centered
around the latch bolt .
Using the flat strike/keeper as
a template drill (2) Ø1/8" pilot
F
holes through one face of the
pilaster only . Secure the flat
strike/keeper with the #10 x 3/4"
flat head screws provided .
Bradley • HDWT-INSTR-010 Rev F; ECN 17-14-007
Installation
Publicidad
Tabla de contenido
