Lavorwash Contractor 2800 Instrucciones De Funcionamiento página 17

anti-action, and then make
•
CaUtIon: Return the starting rope handle gently to
prevent damage to the starter.
9. Preheat the engine and push back the choke lever to
"OPEN" (Fig.14).
fig. 14
•
CaUtIon: Do not allow pressure washer to idle for
more than 2 minutes without switching off. Failure to
do this could cause appliance to the malfunction.
II. StoP
In an emergency, push the engine switch to "OFF"
to stall the engine. Stop it in normal in the following
sequence:
1. Push the engine switch to the OFF position (Fig. 15).
OFF
fig. 15
2. Set the fuel cock to the OFF position (Fig. 16).
fig. 16
• CaUtIon: Turn off the machine when finished
working.
• CaUtIon: When the machine is switched off, always
discharge the pressure hose, opening the gun.
MaIntEnanCE
•
CaUtIon: Before to carry out any kind of maintenance
to the washer machine, run the pressure down, take the
water connection out.
a
rapid pull.
Choke lever
OPEN
Engine switch
OFF
I. LUBrICatIon
Motor: see "owner's manual - general gasoline
engine".
High-pressure water pump: Pump Maintenance:
We recommend the replacement of the oil pump every
100 working hours.
Use oil type 80W-90, 65ml.
II. WatEr SUCtIon FILtEr CHECKInG
Check periodically in order to avoid deposits clogging
it (fig. 17).
fig. 17
III. LonG StoraGE PErIoD
If you forsee/expect to keep the machine in
environments where there is danger of ice/frost or if
you don't use it for more than 3 months, we suggest to
get the machine to intake an antifreeze before putting
it away (similar to that used for cars).
Furthermore, at start-up, small leaks may occur from
the pump; these will disappear after a few hours in
operation. Up to 10 drops a minute are acceptable;
in case of larger leaks contact an Authorised Service
Centre.
troUBLESHootInG
Motor: see "owner's manual - general gasoline
engine".
High-pressure water pump:
17