Hair Removal Program; Information Before Use - Imetec Bellissima Zero Pro Dual Instrucciones De Uso

EN

Hair rEmoVal proGram

A typical cycle of hair growth can take 18 to 24 months. During this time, more
sessions may be required to achieve permanent hair removal.
Hair removal efficacy varies from person to person and in different body parts,
according to the hair colour and level of tolerance of one's own skin.
Recommended treatment plan in a complete hair growth cycle:
• From session 1 to session 4: sessions must be held two weeks apart
from each other.
• From session 5 to session 7: sessions must be held four weeks apart
from each other.
• The subsequent maintenance sessions can be performed from time to
time, when and if necessary, until long-lasting results are achieved.
NotE: the hair removal results will not be enhanced if the same part
of the body is treated more often than recommended (every two weeks).
Dormant hair follicles can be reactivated due to hormonal and physiological
changes. Therefore, occasional hair removal sessions may be required.
The individual reaction depends on the type of hair and biological factors that
may affect the growth cycle of hair. Some people can react quicker or slower
with regards to the recommended hair removal plan.
In any case, a long-lasting result cannot be expected with only one or two
sessions.
the appliance is not effective on white hair. the appliance may be less
effective on natural grey, light blonde and red hair.
50

iNFormatioN BEForE usE

poWEr lEVEl
The appliance can be set to 5 power levels; 1 (lowest) to 5 (highest), indicated
by 5 power level LEDs (5B).
sEttiNG tHE poWEr lEVEl
Press the power level setting and on/off button Each time it is pressed, the
power level increases by 1 up to 5, after which it returns to level 1.
Perform this action until the desired level is set.
The green power level LED (5B) will light up in line with the set power level.
WarNiNG! always start a hair removal session by
setting the energy level detected by the patch test.
sKiN colour sENsor (1B)
Using the pulsed light epilation system on dark skin can cause adverse effects
such as burns, blisters and changes in the colour of the skin (hyper or hypo-
pigmentation).
The appliance has a skin colour sensor (1B) that measures the tone of the
skin in the area that is to be treated at the beginning of each session and
occasionally during the session.
If the skin colour sensor (1B) detects a complexion that is too dark for the
treatment, the appliance stops emitting the light pulses automatically and the
skin colour/device-is-ready LED (5C) starts to flash rapidly.
EN
51