Use - Imetec Bellissima Zero Pro Dual Instrucciones De Uso

EN
• Check the area after 1 hour: if there is no reddening and/or discomfort, it is possible
to start treatment in the tested area at the last energy level setting. If redness persists,
the maximum tolerable power level for your skin type is the previous one. Repeat
the patch test on every part of your body that you wish to treat.
Even though it is extremely rare, if hypersensitivity should persist for over 24 hours, it
is recommended to consult a doctor.
WarNiNG! the power output directly affects the result,
however, due to the principle of heat of the treatment,
the maximum limit tolerated by one's skin must not be
exceeded. this limit is normally high for fair skin and
low for dark skin because melanin, that darkens the
skin, increases the production of heat.
Do Not exceed the maximum limit that your skin
tolerates with no discomfort whatsoever.
prEpariNG tHE arEas tHat arE to BE trEatED
• The skin must be shaved, clean, dry, with no make-up, anti-perspirant
or deodorant.
• On your face, if there are few and thin dark hairs to be treated, it is not
necessary to shave the area, only trim them shorter with scissors. If the
hairs are very short (approximately 1-2 mm) and not too thick, there is no
need to shave nor trim them.
54
• Moles, birthmarks, dark spots, tattoos and lips must be covered with a
white pencil or white patches.
WarNiNG! carefully read all warnings and safety
precautions, possible adverse reactions, treatment
areas and epilation programme.
prEpariNG tHE appliaNcE
1. Remove the appliance and the other components from the package.
2. If the appliance is stored in a very cold place, wait for it to reach at least 15 °C.
3. If the plug has not been inserted into the power supply unit (8), hold the power
supply unit, pull the "Open" key downwards and insert the plug
(8A, 8B or 8C) which is suitable for the socket of the electrical
system, into the relative slot.
4. Insert the cable of the plug (8) into the power supply connection (3).
5. Insert the plug (8) into a socket: all the LEDs on the control
panel (5) will go on and off repeatedly in a circular sequence.
WarNiNG! Do Not use this appliance if there are visible
signs of damage.

usE

EN
55