Publicidad
Idiomas disponibles
Idiomas disponibles
PUSH BASE ONTO
CARRIER MAST.
Insert second bolt with a
washer into adjacent hole.
Position clear sleeve so bolt
can pass through.
Attach washer
and nut.
INSTALL HITCH NUT —
ATTACH BASE TO HITCH.
The hole in hitch must align
to hole in carrier base.
CRADLES HAVE A FRONT AND BACK.
The smooth
depression on
right front side
must face
TOWARD you.
ALIGN HOLES IN MAST AND BASE.
At center hole near end: Insert bolt and washer.
Attach another washer and nut to bolt.
TIGHTEN with adjustable-
end wrenches.
WARNING:
DO NOT
OVER-TIGHTEN
THIS BOLT!
Your product includes a
stop-rivet.
Flex cradles and push over
stop-rivet on mast.
TIGHTEN with
adjustable-end
wrenches.
Insert pin into
holes in plates
and through mast.
LARGE BOLT AND
LOCK-WASHER.
Insert hitch bolt
and washer from
right to left.
Use a 3/4 inch
socket wrench
and TIGHTEN.
The cradle with
YAKIMA should
go on last, with
"YAKIMA" facing out.
Secure wire onto
end of hitch pin.
SECURE hitch bolt
with safety clip.
Publicidad
