vitapur VWD9506W-POU Manual De Uso Y Cuidado página 7

UNLOCKED
Fig. 10
• To attach the filter to the filter head, make sure the "blue locking tab" on the front of filter head is pushed all the way
up (See Fig. 10).
• Screw the filter (1/4 turn clockwise) into the filter head until it stops. Push down the "blue locking tab" into the
locked position (See Fig. 11) If the locking tab fails to engage, (lock) the filter is not sufficiently tightened
(Re- tighten).
• The "red arrow" on the filter head identifies water flow direction (in / out) through the filter.
• The installation is now complete. As with all plumbing installations, the water supply should be turned on slowly
and all connections should be inspected for leaks prior to opening all water valves fully. If any leaks are detected,
immediately close the water supply and repair.
Fig. 13
• To disconnect (remove) the water lines from the filter head, you must first remove the blue locking "c-clip" (See
Fig. 14) by pulling it forward.
• To release the water line from the filter head, simply press and hold the "white" outer collar surrounding the line (See
Fig. 15) while at the same time pulling the water line out. NOTE: These locking "c-clips" must always be installed
"prior" to installation of the water lines.
• To install the water lines, simply insert both lines into their respective openings in the filter head (approx. 13mm
or ½") until they come to a stop.
LOCKED
Fig. 11
Fig. 14
5
Fig. 15