Setting The Timer - Aiwa XR-DV3M Manual De Instrucciones

SETTING THE TIMER

POWER
CURSOR
MODE
a
r,t
ENTER
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1 Press one of the function buttons to select a
source.
If TUNER/BAND is pressed, you will select the band and the
station later in step 8.
2 Press TIMER repeatedly while pressing SHIFT on
the remote control until
appears on the display.
Alternatively, press MODE on the main unit repeatedly until
"TIMER OFF" is displayed, then move CURSOR i or k so
that "TIMER PLAY" appears.
3 Within 4 seconds, press ENTER or a.
Time and audio source name flash alternately.
4 Press r or t to set the timer-on time, then
press ENTER or a.
Holding r or t down will vary the time in 10-minute units.
Alternatively, move CURSOR on the main unit i or k.
5 Within 4 seconds, press r or t to select the
duration for the timer-activated period.
Alternatively, move CURSOR on the main unit i or k.
The duration can be set between 5 and 240 minutes in 5-minute
steps.
TIMER
i/k
ENTER
SHIFT
r,t
POWER
a
and "TIMER PLAY"
Timer-activated period
6 Within 4 seconds, press ENTER or a.
7 Adjust the volume.
The source sound will play at the volume level set in this step
when the power is turned on by the timer.
If the volume level is set to 21 or higher, however, it will
automatically be set to 20 when the power is turned on.
8 Prepare the source.
To play a disc, load the disc to be played.
To listen to the radio, select the band and tune in to a station.
To play the external equipment, set the timer of the connected
equipment (with an external timer) and prepare for the play.
9 Press POWER to turn off the power.
When the timer-on time is reached, the unit turns on and begins
play with the selected source.
To check the timer setting
Press TIMER while pressing SHIFT on the remote control.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Set the timer again from the beginning.
To cancel the timer standby mode temporarily
Press TIMER repeatedly while pressing SHIFT on the remote
control so that disappears and "TIMER OFF" appears.
To restore the timer standby mode, press again to display
When operating on the main unit, press MODE repeatedly until
"TIMER PLAY" is displayed. Then move CURSOR i or k so that
"TIMER OFF" is displayed, and then press ENTER.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out steps 7 and 8.
NOTE
• Timer playback will not begin unless the power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
• To perform timer play on a DVD, set "Disc Resume" to OFF (see
"DISC RESUME", page 47).
• Timer play cannot be done with certain DVDs.
.
En
37
ENGLISH