RIDGID GP80150RTB Manual Del Operador página 21

TROUBLESHOOTING
PROBLEM
Excessive moisture in discharge air.
Compressor runs continuously.
Air output lower than normal.
Compressor cycles on and off
continuously.
Excessive pump oil use.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance
section. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing
to perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause
irreversible engine damage, and/or void your warranty.
NOTE: ILLUSTRATIONS START ON PAGE 24 AFTER
This product has a 90-Day Satisfaction Guarantee Policy, as well
as a Three-year Limited Warranty. For Warranty and Policy details,
please go to www.RIDGID.com or call (toll free) 1-866-539-1710.
POSSIBLE CAUSE
Excessive water in air tanks.
High humidity.
Defective pressure unloader.
Excessive air usage.
Piston rings are worn.
Broken inlet valves.
Connections leaking.
Pressure unloader clogged.
Pump oil cap vent clogged.
Incorrect pump oil.
Pump air filter clogged/dirty.
Too much pump oil in crankcase.
Piston rings worn.
Cylinder scored.
FRENCH AND SPANISH LANGUAGE SECTIONS.
21 – English
SOLUTION
Drain tanks.
Move to area of less humidity; use air
line filter.
Take compressor to a qualified service
center.
Decrease air usage; compressor not
large enough for tool's requirement.
Replace piston rings; Call customer
service for assistance.
Take compressor to a qualified service
center.
Tighten connections.
Take compressor to a qualified service
center.
Remove clog from pump oil cap or
replace cap, if necessary.
Use only SAE 5W-40 synthetic pump oil.
Clean/replace pump air filter.
Drain pump oil to the proper level.
Take compressor to a qualified service
center.
Take compressor to a qualified service
center.