Troy-Bilt STORM 2840 Manual Del Operador página 24

Ocultar thumbs Ver también para STORM 2840:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Back out the stop bolt to increase the clearance between
the friction wheel disc and friction wheel. See Fig. 8-7.
Stop Bolt
7.
Slip the drive belt off the pulley and between friction
wheel and friction wheel disc. See Fig. 8-7.
8.
Remove and replace belt in the reverse order.
24
s
8 — s
ectiOn
ervice
Figure 8-7
Friction Wheel Removal
If the snow thrower fails to drive with the drive control engaged,
and performing the drive control cable adjustment fails to
correct the problem, the friction wheel may need to be replaced.
Follow the instructions below. Examine the friction wheel for
signs of wear or cracking and replace if necessary:
1.
Allow the engine to run until it is out of fuel. Do not
attempt to pour fuel from the engine.
2.
Place the shift lever in third Forward (F3) position.
3.
Carefully pivot the snow thrower up and forward so that it
rests on the auger housing.
4.
Remove the frame cover from the underside of the snow
thrower by removing the self-tapping screws which secure
it. Remove the right-hand wheel by removing the screw
and bell washer which secure it to the axle. See Fig. 8-8.
Figure 8-8

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido