Storage - Wilo Rexa CUT GI Instrucciones De Instalación Y Funcionamiento

Fig. 2: Attachment point
5.3

Storage

Installation and operating instructions Wilo-Rexa CUT GI
Transport and storage
NOTICE
Use only technically faultless lifting equipment!
Use only technically faultless lifting equipment to lift and lower the pump. Make sure
that the pump does not jam during lifting and lowering. Do not exceed the maximum
bearing capacity of the lifting equipment! Check that lifting equipment is functioning
properly before use!
CAUTION
Wet packaging can tear!
The product may fall on the ground if unprotected and may be damaged. Lift wet pack-
aging carefully and replace it immediately!
To protect the pump from damage during transport, only remove the outer packaging at the
operation site. Pack used pumps for shipping in tear-proof plastic bags of sufficient size so
that they are leakproof.
Furthermore, observe the following points:
▪ Adhere to national safety regulations.
▪ Use legally specified and permitted lifting gear.
▪ Select lifting gear according to the present conditions (weather, attachment point, load
etc.).
▪ Only attach lifting gear to attachment points. The fixation must be made with a shackle.
▪ Use lifting equipment with sufficient bearing capacity.
▪ The standard safety of the lifting equipment must be guaranteed during application.
▪ When using lifting equipment, get a second person to coordinate the procedure if necessary
(e.g. view blocked).
DANGER
Danger due to fluids which are hazardous to health!
When the pump is used in fluids which are hazardous to health, decontaminate the pump
after removal and before all work! There is a risk of fatal injury! Observe information from
the work regulations! The operator must ensure that the personnel have received and
read the work regulations!
WARNING
Attached macerator: sharp edges on the cutting plate and rotating blade!
The macerator can cause amputation of limbs! Wear safety gloves to protect against cuts
and never reach into the macerator!
en-US
15