Initial Configuration - Palazzetti ECOFIRE GINGER Generalidades - Advertencias - Instalación - Mantenimiento

Ocultar thumbs Ver también para ECOFIRE GINGER:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

After making the water connections, it is necessary to proceed with the boiler load (tap C) and the related vent
(B), monitoring the pressure (1-1.2 bar cold) through the pressure gauge (A).
If necessary ensure that the closed expansion vessel (G) preload is correct.
MAXIMUM OPERATING PRESSURE: 2,5 bar
It is good practice to proceed with washing the system before commissioning the operational system.
that the water hardness of the system is less than 25-27 French degrees and to add anti-algae treatment to the
system's water as necessary.

5.9 INITIAL CONFIGURATION

Before proceeding, power up the stove.
Use the arrow buttons to scroll between the icons until reaching the setup menu
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Use the
d) Press
and enter the value "54" using the
e) Press
f)
g)
h) Press
seconds. Ignore this and switch the stove off using the safety switch on the rear, wait a few seconds
and switch it back on.
FIVE DIFFERENT CONFIGURATIONS ARE AVAILABLE:
CONFIGURATION 1
thermostat, but rather leaving the two terminals jumpered as per the factory setting.
modulates output (to minimise fuel consumption) when reaching the set water temperature.
The stove will turn off also in case the water temperature continues to rise despite the modulation. In this case,
the stove will turn on only if the temperature difference between the value you set up and the real one is higher
than 20°C.
CONFIGURATION 2
the central heating radiators.
The stove will modulate output according to the room temperature read by the probe on the stove.
The "Eco-mode" function can be used to have the stove switch off or on based on the set room temperature.
CONFIGURATION 3
The stove will be controlled (switch on and off) based on the temperature read by the probe in the storage tank.
to go to the setup menu
buttons to scroll to and select submenu
and then press
;
[30]
--0
; "
buttons;
;
buttons;
33

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ecofire elisabethEcofire noahEcofire idro

Tabla de contenido