EMAK CROSSJET TUAREG 92 EVO Manual De Usuario página 39

Perform the replacement as follows:
 Place the jack underneath the front or rear bumper near to the wheel
which you wish to replace. For model AC 92-23 4x4 – always place the jack
against the frame - do not lean it on the transmission, this could damage it!
 Keep lifting the machine until the wheel, which you wish to change no
longer touches the ground.
 Remove the protective cover from the wheel.
 Using a suitable screwdriver remove the retaining ring and remove the
washer.
 Pull the wheel off the shaft.
When reattaching the wheel proceed in the reverse sequence to its removal. Before attaching the
wheel clean all parts and lightly grease the shaft with a plastic lubricant. Especially for wheels on the
rear axle this lubrication is essential for the subsequent removal of the wheel. In the event
that lubrication is not performed the subsequent attachment may be very difficult.
When attaching the rear wheel pay attention to the mutual alignment of the pin on the shaft and the
groove on the wheel.
Finally check the tyre pressure.
6.3.12 REPAIRING A TYRE PUNCTURE
The machine is equipped with tubeless tyres. In the event of a puncture have it repaired at a specialised
tyre repair shop or at an authorised Seco machine service centre.
6.3.13 MAINTENANCE OF THE HYDROSTATIC TRANSMISSION
For the reliable operation of the transmission it is necessary to maintain the correct oil
level. In the event of problems with the transmission immediately seek the help of an
authorised service centre, there is a risk of serious damage to the transmission.
Machine
model
AC 92-18(20) SAE 10W-40, API CD
AC 92-23 4x4 SAE 5W-50 synthetic oil
In the event of problems with the transmission immediately seek the help of an authorised
service centre, there is a risk of serious damage.
Oil type
At least to half the height of the equalisation tank
Between the marks on the dipstick in the tank cap
(total oil volume in the hydraulic system is 6l)
39
Oil level
6.4