Ki Mobility ROGUE XP Manual De Instrucciones Y Garantía página 24

V. SET UP & USE OF YOUR WHEELCHAIR
G. Center of Gravity Adjustment
To adjust the center of gravity location:
a. Remove both rear wheels.
b. Loosen the two screws (Fig. 9:C) and nuts that secure the camber mounts (Fig. 9:A and B)
to the seat tubes on each side of the frame.
c. Grasp both sides of the camber tube and move the camber mounts forward or rearward
along the seat tube, aligning holes on frame with holes on camber mount (Fig. 9:D).
d. Make sure the mounts on both sides of the frame are adjusted equally on both sides of the
frame before reinserting screws and nuts. Tighten until secure.
e. Once the camber mount clamps are secured, attach the rear wheels, occupy the chair and
manuever it with a spotter to get a feel for the new adjustment.
WARNING: The more you move your rear wheels forward, the more likely your chair will tip over
backwards. Always make adjustments in small increments and check the stability of your chair
with a spotter to prevent a tip over. We recommend that you use anti-tip tubes until you adapt to
the change and are sure you are not at risk to tip over.
DANGER: Failure to heed these warnings may cause serious injury or death.
Fig. 9
B
D
C
22
A