Cleaning; Maintenance And Repair; Maintenance; Repair - Ottobock 491S75 ST610 Instrucciones De Uso

WARNING
Using the product with certain settings and/or installed accessories
Severe injury in case of accidents due to accessories coming loose
► Before using the product as a seat in a vehicle for transporting persons with reduced mobility, remove
accessories that need to be dismantled for safe transportation in a vehicle for transporting persons with
reduced mobility. Observe the information on the main product in the instructions for use.
► Stow all dismantled accessories securely in the vehicle for transporting persons with reduced mobility.
Prior to the use of the "Dahl docking system" in a vehicle for transporting persons with reduced mobility, it must be
ensured that the protective aids supplied by Ottobock are attached to the seat of the power wheelchair (protective
pads for VAS seat: see fig. 10; edge protection for standard seat: see fig. 11). This is the only way to ensure that
the occupant restraint belts are not damaged by sharp corners in case of a crash.
For the use of the power wheelchair, attention must also be paid to the information provided in the instructions for
use for the main Ottobock product, in particular the section "Use in vehicles for transporting persons with reduced
mobility".
For the use of the Dahl docking system in vehicles for transporting persons with reduced mobility, attention must
be paid to the instructions for use in the operating instructions by the manufacturer, Dahl. This applies in particular
to the following contents:
• Attachment of the wheelchair in the docking station
• Release from the docking station

7.3 Cleaning

Cleaning the attachments supplied by Ottobock (protective pads, edge protection)
The pads can be machine-washed in warm water up to max. 60 °C (140 °F), using a mild detergent.
•
• Clean the hook-and-loop closure with a dry brush.
• Allow the product to fully air dry before use.
• Do not expose the product to direct heat (e.g. sunshine, stove or radiator heat, hair dryer).
Cleaning the parts of the Dahl docking system
For cleaning the parts of the Dahl docking system, attention must be paid to the information in the operating
instructions by the manufacturer, Dahl.

8 Maintenance and repair

8.1 Maintenance

Maintenance instructions for the attachments supplied by Ottobock (protective pads, edge protection)
• Maintenance is not required if the attachments are cleaned regularly.
Maintenance instructions for the "Dahl docking system" option
• For correct maintenance, attention must be paid to the information in the operating instructions by the manufac­
turer, Dahl.
• The function of the product should be checked before each use.
• The product may not be used if defects are noted. This applies in particular in case of instability of the product
or altered driving characteristics as well as problems with the user's seating position or the stability of the seat.
Inform the qualified personnel promptly for the rectification of defects.
• This also applies if loose, worn, bent or damaged components, cracks in the frame or broken frame compon­
ents are identified.
• Failure to maintain the product can lead to injuries for the user of the product.

8.2 Repair

Repair instructions for the attachments supplied by Ottobock (protective pads, edge protection)
• In case of damage, promptly contact the Ottobock service department (see inside back cover or back page for
the address).
Repair instructions for the "Dahl docking system" option
• In case of damage, promptly contact the qualified personnel who adapted the product or the manufacturer's
service department (for the address, see the enclosed operating instructions of the manufacturer, Dahl).
491S75=ST610, 491S75=ST615
Maintenance and repair
19