Technical Features; User Safety; Set Up For Installation - Jacuzzi J-400 Manual Del Usario

It is the responsibility of the installer/owner to ascertain com-
pliance with specific local regulations prior to installation.
Jacuzzi Europe S.p.A. gives no guarantee in this respect and
refuses all responsibility regarding compliance of the instal-
lation carried out.

Technical Features

The Jacuzzi spas feature a single-phase power supply (220-240
V). All electro-mechanical parts and pipes are enclosed.
- J-425/435/445/475/485 spas are equipped with 2 hydromas-
sage pumps plus a recirculation pump.
- J-495 spas are equipped with 3 hydromassage pumps plus a
recirculation pump.
Maximum absorption of the system
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table).
Power supply
(single-phase)
Volt
J-425
220-240 ~
J-435 220-240 ~
J-445 220-240 ~
J-475 220-240 ~
J-485 220-240 ~
J-495 220-240 ~
(k): a 230V (single-phase) / (j): max. power absorption
If sufficient electrical energy is not available, an electronic energy
consumption limiter can be activated from inside the electronics box.
This operation can only be performed by authorized Jacuzzi®
technicians and limits electricity consumption as follows:
- J-425/J-435/J-445/J-475/J-485
Alternative consumption: 3.9kW/17A (by activating a pump, the
electric heater switches off).
- J-495
Alternative consumption: 6.7kW/29A (by activating three pumps,
the electric heater switches off).
Tot. Consumption:
electric heater + pump(s)
Hertz Ampere
(k)
50 30
(k)
50 30
(k)
50 30
(k)
50 30
(k)
50 30
(k)
50 37
Weights
net weight
kg
J-425 ~ 352
J-435 ~ 373
J-445 ~ 388
J-475 ~ 419
J-485 ~ 415
J-495 ~ 495

User safety

The system, if installed by qualified personnel, does not pres-
ent any hazard for the user. Safety is however also contingent
upon proper use, as set forth by the user's manual included with
the product. The user must contact qualified personnel for spe-
cial operations described in the manual.
It is important to make sure that personnel tasked to install
and manage the system are qualified as per legal requirements in
effect in the country where installation is carried out.
This appliance uses and generates radio waves: if it is not in-
kW
stalled and used as directed, it may cause interference with the
(j)
6,9 reception of radio and television programs.
However, in special cases this may happen even if the directions
(j)
6,9
provided are followed.
(j)
6,9
(j)
6,9
(j)
6,9
(j)
8,5

Set up for installation

The site where the spa will be installed must be de-
signed to ensure the possible removal and reloca-
tion of the spa itself, if necessary.
Position the spa away from glass and/or reflective sur-
faces in order to avoid possible damage to its panel-
ling.
The customer must make provisions for a ground drainage
point ( 8) of suitable dimensions and that can be inspected for
any cleaning that may be required.
ATTENTION: Before preparing the drainage system
to connect the spa to, consult the local authorities
about the regulations for disposing of chemically
treated water.
Jacuzzi® spas are equipped with a drain as in
and 8.
For periodic emptying of the spa you can connect a rubber
hose to the drain valve (
16
average fill maximum total
water volume max. weight
litres litres kg
~ 1211 ~ 1590 ~ 1942
~ 1363 ~ 1666 ~ 2039
~ 1438 ~ 1666 ~ 2054
~ 1666 ~ 2025 ~ 2444
~ 1647 ~ 2006 ~ 2421
~ 1893 ~ 2536 ~ 3031
1-7, part.A-C and
support load concentrated
area on support area
m2 kg/m2
~ 3,78 ~ 514
~ 4 ~ 510
~ 4 ~ 513
~ 4,75 ~ 514
~ 4,75 ~ 510
~ 5,66 ~ 535
1-7, part.A-C
8).