Installing The Anti-Tip Device - Viking Range 5 Serie Manual De Instalación, Operación Y Mantenimiento

INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS
WARNING
!
•
•
•
Anti-Tip Device
WARNING
!
If your refrigerator is not located under a counter
top (free standing), you must use an anti-tip device
installed as per these instructions. If the refrigerator is
removed from its location for any reason, make sure
that the device is properly engaged with the anti-tip
bracket when you push the refrigerator back into the
original location. If the device is not properly engaged,
there is a risk of the refrigerator tipping over, with the
potential for property damage or personal injury.
NOTE
If installing on a concrete fl oor, concrete fasteners are
required, (not included with the anti-tip kit).
CAUTION
!
Any fi nished fl ooring should be protected with appropriate
material to avoid damage when moving the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the fl oor in the left
or right rear corner of the refrigerator drawer as shown in
Figure 7.
ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
FOLLOW THE INSTRUC-
TIONS BELOW
Anti-Tip
Bracket
Leveling Leg
Bottom View of
21 ⁄ "
1
2
Refrigerated
(54.6 cm)
Drawer Unit
Figure 7
Step by step instructions for locating the po-
sition of the bracket:
1) Decide where you want to place the drawer refrigerator.
Slide it into place, being careful not to damage the fl oor,
leaving 1" (2.5 cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the fl oor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the fl oor marking the front corner
of the cabinet, excluding the drawer. Slide the refrigerator
out of the way. From the temporary line extend the sidewall
line back 21 ⁄ " (54.6 cm) as shown in Figure 8.
1
2
4) Align the anti-tip bracket to the marks on the fl oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21 ⁄ " (54.6 cm) line (Rear of cabinet
1
2
line).
5) Fasten the anti-tip bracket to the fl oor using the supplied
screw. (See Figure 8).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
6
Front of cabinet
⁄ " (6 mm) to
1
4