Setting Date/Time - smartheart 01-572 Manual De Instrucciones

SETTING DATE/TIME

IT IS NECESSARY TO SET THE DATE AND TIME FOR THE
UNIT EVERY TIME BATTERIES ARE INITIALLY INSTALLED OR
REPLACED
The date/time feature is on the lower right of the display screen. This unit stores
the date and time, including year allowing for a date/time stamp on all readings
in the memory recall function.
1. When the batteries are first installed, the device will automatically prompt you
to set the Date/Time feature.*
*NOTE: If the batteries have already been installed—when the unit is off (a
blank display screen), press and hold the S (SET) button for 3-5 seconds to
make the unit go into clock setting mode.
2. YEAR—next the year will flash on the display. Press the M button to advance
the display to the desired year, press the S button to confirm your selection
and advance to the date settings.
3. MONTH/DATE—repeat the same sequence of step 2 to confirm the MONTH
and DATE setting.
4. HOURS/MINUTES—repeat the same sequence of step 2 to confirm the
HOUR and MINUTE setting.
5. After the Date/Time setting function is complete, the monitor is ready for use.
10 • ENGLISH
The Memory, Set and Start•Stop buttons are
located on the right side of the display.
MEMORY button
M
SET button
START STOP button