Setting Date And Time - smartheart 01-539 Manual De Instrucciones

SETTING DATE/TIME
IT IS NECESSARY TO SET THE DATE AND TIME FOR THE UNIT EVERY
TIME BATTERIES ARE INITIALLY INSTALLED OR REPLACED.
DATE AND TIME WILL DEFAULT TO FACTORY SETTINGS, 12:00 A.M. /
1(M)-1(D), IF YOU DO NOT CHOOSE TO SET THE CORRECT DATA.
The date/time feature is on the bottom left of the
display screen, Fig 1. The date and time will
alternate every four seconds regardless of the
operating mode.
1. When the unit is off, press and hold the START
and MEM button at the same time. The unit will
beep once and the month will begin to flash,
Fig. 2.
2. Press the MEM button to advance the month
until the desired number appears. To scroll
through the numbers quicker, hold down the
MEM button as the numbers advance.
3. Press the START button to confirm the month
entry.
4. next, the date will blink. Repeat steps 2 and 3
to set the date, then hours, then minutes. This
unit does not track the year.
5. After setting the minutes, the unit will
automatically exit out of the date/time setting
mode and is ready to take a measurement.
10 • ENGLISH
DATE
screen display
TIME
screen display
Fig. 1
Fig. 2