Troubleshooting - Zummo MFD14 Manual Del Usuario

•
Assemble the turbine and turbine/pump cover, clipping on the pump cover fixing
clip.
•
Rinse the bottom of the tank with clean water to eliminate any possible detergent
residue. Dry the inside of the tank with kitchen paper.
7

TROUBLESHOOTING

PROBLEM
1. Nothing functions in the unit.
2. The turbine does not work.
3. The compressor does not start, although
there is power.
4. The juice does not cool.
5. Dripping tap.
6. The tank leaks juice.
* Call the technical service.
CAUSE
1.1.- There's no current from the outlet where the unit is
plugged in.
1.2.- The electrical wire is defective.*
1.3.- The on/off switch is faulty.*
1.4.- The switch connections are defective.*
2.1.- Defective motor connection.*
2.2.- The motor is not operating properly.*
3.1.- Start-up relay.*
3.2.- Heat protector.*
3.3.- Compressor.*
4.1.- Dirty condenser, remove the grate (fig 4) and clean
it.
4.2.- Insufficient ventilation around the unit, make sure
there is a gap of 15 cm around the whole unit.
4.3.- Faulty condenser fan.*
4.4.- Coolant gas leak.*
4.5.- Faulty thermostat.*
4.6.- Stirrer blocked.*
5.1.- Check that the faucet joint is in a good condition.
5.2.- Too much pulp in the juice: check that the filter is
fitted in the juicer unit.
6.1.- Faulty tank gasket.
6.2.- Wrong placed tank.
14