General Parts Knowledge; Assembly; Stand Assembly - Delta ShopMaster S36-300 Manual De Instrucciones

BLADE GUARD
TABLE
SCALE
FENCE RAIL
HEIGHT
ADJUSTMENT
WHEEL
ON/OFF
SWITCH
BEVEL
LOCK
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents,
and the Hardware Contents.
• When lifting saw, hold it close to your body while lifting.
Keep knees bent and lift with your legs, not your back.
• Fully assemble saw with stand assembly prior to use.
• Stand assembly is an integral and necessary part of
the support structure for this saw. Do not attempt
to substitute a table or other surface for the stand

assembly.

STAND ASSEMBLY

Assemble stand part 2 (I) through stand part 1 (H) that has
cross support as shown in Fig. 1. Secure stand assembly
with M8 x 65mm hex socket head bolt (d), M8 spacer (c),
M8, flat washer (b) and M8 lock nut (e) (Fig. 1)
NOTE: M8 spacer (c) is between stand part (H) and (I).
Fig. 2 for correct stand parts setup.

GENERAL PARTS KNOWLEDGE

ASSEMBLY
• Do not modify saw, or create accessories not
recommended for use with this saw.
• Do not connect to power supply until assembly is
complete. Make sure power switch is in "OFF" position
before connecting to power supply.
• Avoid contact with blade teeth. Keep blade stored or
lowered when possible.
H
10
RIVING KNIFE
ANTI-KICKBACK PAWLS
THROAT PLATE
FENCE LOCK
OUTFEED EXTENSION
RIP FENCE
BLADE WRENCHES
(NOT VISIBLE)
PUSH STICK
BEVEL SCALE
MITER GAUGE
STAND
e
c
FIGURE 1
d